Skip to content

316L Stainless Steel Tube Butt Weld (TBW) Fittings, Bright Annealed, CFOS

This article is about 316L Stainless Steel Tube Butt Weld (TBW) Fittings, Bright Annealed, CFOS and technical specification based on international codes and standards of ASME SA-479 and ASME SA-182.

316L Stainless Steel Tube Butt Weld (TBW) Fittings, Bright Annealed, CFOS

Scope Description 316L stainless steel. Bright annealed (BA), tube butt weld fittings. cleaned for oxygen service (CFOS)
Material Specification Manufacturer’s standard supply conforming to ASME SA-479 and ASME SA-182, Grade 316L.
Lengths, Tolerances Not applicable.
Dimensional

Specification

Manufacturer standard.
Purchase Order The Purchase Order (PO) shall specify the following:

1.   Type of fitting, size [DN (NPS) and/or tube OD], and quantity.

2.   Marking or tagging (see Marking section of this specification).

3.   Specific packaging standards and instructions.

4.   Cleaning requirement (see Special Requirements section of this specification).

Drawings Supplier shall provide drawings that specify all dimensions of fittings.
Inspection Company  inspection is not required, unless specified in the PO.
Testing Company  witnessing of tests is not required, unless specified in the PO.
Examination Company  witnessing of examination is not required, unless specified in the PO.
Marking Markings shall be those required by the material specification and those that are manufacturer’s standard identification. Additional marking or tagging required by Company  shall be specified in the PO.
Protection The manufacturer or supplier shall provide any special protection or packaging, and details of any storage, shelf life, or maintenance instructions that pertain to the manufacturer or supplier’s guarantee or are otherwise necessary for the protection of the items.
Packing Suitable packaging shall be provided to ensure that all items are protected from damage during handling and shipment. Any component received by Company  in a damaged condition shall be returned and replaced, all at the supplier’s expense. Damage also includes a torn bag and loss of purge gas environment. Refer to the PO for specific packaging standards and instructions.
Special Requirements Cleaning: Cleaning shall be performed in a Class 1000 cleanroom or clean zone. Cleaning of tube and fittings shall be performed per supplier’s cleaning specification. A final rinse shall be made with deionized water and the effluent shall be monitored for resistivity. The acceptable resistivity level is ≥ 16 megaohm-cm. The following is a recommended cleaning method:

Step 1: Wash by submerging in multi-stage continuous counter-flowing deionized water baths. Final rinse with a 60°C (140°F) deionized water spray.

Step 2: Dry by purging with 99.999% pure, 0.01 micron filtered, 60°C (140°F) nitrogen. For fittings, bake off residual moisture by using a vacuum oven or a heat lamp.

Certificate of

Conformance

A certificate of conformance shall be submitted with each shipment by which the manufacturer or supplier certifies that the purchased components are in accordance with the requirements of this material purchase specification and the PO. Objective evidence of compliance shall include the certification required in General Piping Material Purchase Specification..

The following shall be noted on the certificate of conformance: Company  PO number, supplier lot number, mill heats used to fill order, shipping order number, date, and signature of supplier’s Quality Control Representative.

 

Leave a Reply

Your email address will not be published. Required fields are marked *