Skip to content

FITTINGS: HUB, CLAMPs and SEAL RINGs API-6A or Proprietary design. |  INSPECTION & TESTING

TEST AND INSPECTION PER:  API-6A, NACE MR-01-75 / ISO 15156 and Specifications As Noted Below

FITTINGS: HUB, CLAMPs and SEAL RINGs API-6A or Proprietary design. |  INSPECTION & TESTING

Pre-Fabrication/Production Requirements

Specification Details / Notes:

Inspection and Test Plan Shall be submitted to company Inspector for review and approval
Material Test Reports API-6A, PSL 3 or Per Manufacturer standards as applicable
Heat treatment Certificate and Chart API-6A, PSL 3 or Per Manufacturer standards as applicable

In process inspection & test requirement

Specification Details / Notes:

Workmanship, Material, Surface defects, components and dimensional verification API-6A, PSL 3 or Per Manufacturer standards as applicable
Chemical analysis API-6A, PSL 3 or Per Manufacturer standards as applicable
Traceability and Serializations API-6A, PSL 3 or Per Manufacturer standards as applicable
PMI For Hubs and clamps. To be performed on identified blanks immediately before fabrication
Tensile Test & Impact test API-6A, PSL 3 or Per Manufacturer standards as applicable
Hardness test API-6A, PSL 3 , Per NACE MR-01-75 / ISO-15156 or Per

Manufacturer standards as applicable

Volumetric NDE API-6A, PSL 3 or Per Manufacturer standards as applicable
Surface NDE API-6A, Section 7, PSL 3 or Per Manufacturer standards as applicable

Final inspection & test requirements

Specification Details / Notes:

Visual and Dimensional Inspection API-6A, PSL 3 or Per Manufacturer standards as applicable
Inspection of Raised Face Gasket Surface Per Applicable ASTM
Markings API-6A, PSL 3 or Per Manufacturer standards as applicable
Protective Coating, End Covers & Packaging API-6A, PSL 3 or Per Manufacturer standards as applicable

Additional/Supplemental Requirements

Specification Details / Notes:

Other if any per PO  

FITTINGS: HUB, CLAMPs and SEAL RINGs API-6A or Proprietary design. |  INSPECTION & TESTING

FITTINGS: HUB, CLAMPs and SEAL RINGs API-6A or Proprietary design. |  INSPECTION & TESTING

FITTINGS: HUB, CLAMPs and SEAL RINGs API-6A or Proprietary design. |  INSPECTION & TESTING

Leave a Reply

Your email address will not be published. Required fields are marked *