TEST AND INSPECTION PER: API-6A, NACE MR-01-75 / ISO 15156 and Specifications As Noted Below
FITTINGS: HUB, CLAMPs and SEAL RINGs API-6A or Proprietary design. | INSPECTION & TESTING
Pre-Fabrication/Production Requirements |
Specification Details / Notes: |
| Inspection and Test Plan | Shall be submitted to company Inspector for review and approval |
| Material Test Reports | API-6A, PSL 3 or Per Manufacturer standards as applicable |
| Heat treatment Certificate and Chart | API-6A, PSL 3 or Per Manufacturer standards as applicable |
In process inspection & test requirement |
Specification Details / Notes: |
| Workmanship, Material, Surface defects, components and dimensional verification | API-6A, PSL 3 or Per Manufacturer standards as applicable |
| Chemical analysis | API-6A, PSL 3 or Per Manufacturer standards as applicable |
| Traceability and Serializations | API-6A, PSL 3 or Per Manufacturer standards as applicable |
| PMI | For Hubs and clamps. To be performed on identified blanks immediately before fabrication |
| Tensile Test & Impact test | API-6A, PSL 3 or Per Manufacturer standards as applicable |
| Hardness test | API-6A, PSL 3 , Per NACE MR-01-75 / ISO-15156 or Per
Manufacturer standards as applicable |
| Volumetric NDE | API-6A, PSL 3 or Per Manufacturer standards as applicable |
| Surface NDE | API-6A, Section 7, PSL 3 or Per Manufacturer standards as applicable |
Final inspection & test requirements |
Specification Details / Notes: |
| Visual and Dimensional Inspection | API-6A, PSL 3 or Per Manufacturer standards as applicable |
| Inspection of Raised Face Gasket Surface | Per Applicable ASTM |
| Markings | API-6A, PSL 3 or Per Manufacturer standards as applicable |
| Protective Coating, End Covers & Packaging | API-6A, PSL 3 or Per Manufacturer standards as applicable |
Additional/Supplemental Requirements |
Specification Details / Notes: |
| Other if any per PO |
