TEST AND INSPECTION PER: ASME B16.5 and Specifications As Noted Below
FLANGES: Socket weld and Threaded, All materials covered by ASME B1
| Pre-Fabrication/Production Requirements | Specification Details / Notes: |
| Forging Process procedure | All flanges must be forged, cast flanges are not permitted |
| Material Test Reports of Cast or Heat Analysis, Product analysis and Carbon equivalent | Per Applicable ASTM |
| NDT Procedures and Personnel | Verify valid personnel qualification and approved procedure |
| In process inspection & test requirement | Specification Details / Notes: |
| Heat Treatment | Per Applicable ASTM |
| Mechanical Testing: Tensile Test, Impact test and Hardness test | Per Applicable ASTM |
| Grain Size | Per Applicable ASTM |
| Magnetic Particle Testing and Liquid penetrant Testing | Per Applicable ASTM or 10% of each lot whichever is greater |
| Final inspection & test requirements | Specification Details / Notes: |
| Dimensional Inspection | ASME B16.5 / Industrial Standard and approved drawings |
| Inspection of Gasket face Surface | Per ASME B16.5 |
| Markings | Utilize respective ASME standards |
| Protective Coating, End Covers & Packaging | If required |
| Special Flange Dimensions (when applicable) | Apply the approved #Special Design#. |
| Additional/Supplemental Requirements | Specification Details / Notes: |
| Other if any per PO |
Notes:
- May only be waived by the responsible Saudi Aramco, ASC, or AOC Inspection
See form SA 175 -000003 for instructions on using this form.
