ISO 5167-3 is a part of the ISO 5167 series of standards that specifies the geometry and method of use (installation and operating conditions) of flow nozzles when they are inserted in a conduit running full to determine the flowrate of the fluid flowing in the conduit.
This standard provides detailed guidelines for the design, installation, and calibration of flow nozzles, which are primary devices used for fluid flow measurement in various industries. It also offers background information and equations for calculating the flowrate based on the pressure differential created by the flow nozzle.
ISO 5167-3 is intended to be used in conjunction with the requirements given in ISO 5167-1, which provides general principles and requirements for flow measurement using orifice plates, nozzles, and venturi tubes.
In summary, ISO 5167-3 is a specific standard that focuses on flow nozzles and provides essential information for their accurate and reliable usage in fluid flow measurement applications.
ISO 5167-3 PDF Download
iso_5167_3_2003_nozzles-and-venturi-nozzlesNozzles and Venturi nozzles
This article is about measurement of fluid flow by means of Nozzles and Venturi nozzlez of pressure differential devices inserted in circular-cross section conduits running full.
ISO 5167-3 specifies the geometry and method of use for nozzles and Venturi nozzles when inserted in a conduit running full to determine fluid flowrate. It also provides background information for flowrate calculations and is used in conjunction with ISO 5167-1 requirements.
This standard is applicable to nozzles and Venturi nozzles with subsonic flow throughout the measuring section and single-phase fluid. Each device has specified limits for pipe size and Reynolds number and is not suitable for measuring pulsating flow. It does not cover pipe sizes below 50 mm or above 630 mm, or Reynolds numbers below 10,000.
ISO 5167-3 covers two types of standard nozzles: the ISA 1932 nozzle and the long radius nozzle. It also includes the Venturi nozzle, which has a lower pressure loss compared to similar nozzles. Direct calibration experiments were conducted to establish coherent application systems and provide coefficients within predictable limits of uncertainty for these devices.
Read Also:
- ISO 5167-1 Download PDF – Measurement of fluid flow by means of pressure differential devices Part 1
- ISO 5167-2 Download PDF – Orifice plates
- ISO 5167-4 PDF Download – Venturi tubes
- ISO 5167-5 PDF Download – Cone meters
- ISO 5167-6 PDF Download – Wedge meters
FAQs:
ISO 5167-3 specifies the geometry and method of use for nozzles and Venturi nozzles when inserted in a conduit running full to determine the flowrate of fluid flowing in the conduit.
ISO 5167-3 also provides background information for calculating the flowrate and is used in conjunction with the requirements given in ISO 5167-1.
ISO 5167-3 covers two types of standard nozzles: the ISA 1932 nozzle and the long radius nozzle. It also includes the Venturi nozzle.
ISO 5167-3 is applicable to nozzles and Venturi nozzles with subsonic flow throughout the measuring section and where the fluid can be considered as single-phase. It does not cover the measurement of pulsating flow.
Yes, each device can only be used within specified limits of pipe size and Reynolds number. The standard does not apply to pipe sizes less than 50 mm or more than 630 mm, or where the pipe Reynolds numbers are below 10,000.
Pingback: ISO 5167-5 PDF Download - Cone meters - PDFYAR - Engineering Notes, Documents & Lectures