Skip to content

Plant Paging System Specification General and Codes References

Plant Paging System Specification General and Codes References

  • This specification describes the Site Personnel Paging System, (Permanent Plant), for point-to-point and point-to-multi-point communications within the Facility
  • The Contractor shall provide all equipment, accessories, and materials necessary for the Owner Project Site. The paging system shall be used for permanent site
    communications. The system shall be complete, fully operational and meet all the Owner’s on site communications requirements.
  • The purpose of the personnel paging system shall be to provide fully digital, duplex voice communication capability as required to provide instant staff to staff intercommunications,
    emergency paging and signaling, and audio distribution for personnel safety, facility security, operational efficiency, and maintenance functions.
  • All the system equipment installed shall comply with NEC and shall be rated for the site classification in which it is installed.

Plant Paging System Codes & References

The publications listed below form part of this specification. Each publication shall be the latest revision and addendum in effect on the date this specification is issued for bid
unless noted otherwise. Any conflicts noted between this specification and the documents stated below shall be brought to the attention of the Owner.

American National Standards Institute (ANSI)

TIA-568 Commercial Building Telecommunications Cabling Standards
TIA-569 Commercial Building Standard for Telecommunication Pathways and Spaces

Federal Communications Commission (FCC)

Part 15, Sub part J – RF Interference

National Electrical Code 9NEC)

NEC Chapter 8 – Communications

System Test Plan of Plant Paging System

System Operational Requirements of Plant Paging System

System Functional Requirements of Plant Paging System

Leave a Reply

Your email address will not be published. Required fields are marked *